2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

REPAIR

Removal / installation · Vehicles built from Sep 2011


1. INSPECT WINDOW GLASS ANTENNA WIRE

B066134E02

NOTICE:
When cleaning the glass, use a soft, dry cloth, and wipe the glass in the direction of the wire. Take care not to damage the wires. Do not use detergents or glass cleaners with abrasive ingredients. When measuring voltage, wind a piece of tin foil around the top of the probe and press the foil against the wire with your finger, as shown in the illustration.

  1. E032576
    Check the voltage at the center of each wire, as shown in the illustration.


2. REPAIR WINDOW GLASS ANTENNA WIRE

B063722E02
  1. Clean the broken wire tips with grease, wax and silicone remover.

  1. Place masking tape along both sides of the wire to be repaired.

  1. Thoroughly mix the repair agent (DuPont paste No. 4817).

  1. B063723E01
    Using a fine tip brush, apply a small amount of the repair agent to the wire.

  1. After a few minutes, remove the masking tape.

    NOTICE:
    Do not allow electricity to flow in the antenna wire for at least 24 hours.

← INSTALLATION (from Jan 2012)PRECAUTION (from Jan 2012) →