DATA LIST / ACTIVE TEST
System information · Vehicles built from Sep 2011
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on intelligent tester, read the "Data List".
Entry&Start Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Intrusion sensor OFF
Intrusion sensor cancel switch /
ON or OFF
ON: Intrusion sensor active (switch off)
OFF: Intrusion sensor not active (switch on)
-
Intrusion sensor detection
Intrusion sensor setting /
ON or OFF
ON: Moving object detected by sensor during arming preparation state to armed state
OFF: No moving object detected by sensor
-
Tilt sensor detection
Tilt sensor setting /
ON or OFF
ON: Tilt sensor set
OFF: Tilt sensor not set
-
Hood Courtesy Switch
Engine hood courtesy switch /
ON or OFF
ON: Engine hood open
OFF: Engine hood closed
-
Warn By Horn
Security horn /
ON or OFF
ON: Security horn sounding
OFF: Security horn not sounding
-
Glass break sensor detection
Glass breakage sensor detection /
ON or OFF
ON: Glass breakage sensor operates
OFF: Glass breakage sensor does not operate
-
Pattern Glass Connection
Pattern Glass Connection /
OK or NG
OK: Pattern glass connection
NG: No pattern glass connection
-
Intrusion sensor 1 communication
Intrusion sensor setting /
OK or STOP
OK: Intrusion sensor set
STOP: Intrusion sensor not set
-
Tilt sensor communication
Tilt sensor setting /
OK or STOP
OK: Tilt sensor set
STOP: Tilt sensor not set
-
Tilt sensor OFF Switch
Tilt sensor OFF switch /
ON or OFF
ON: Tilt sensor active (switch off)
OFF: Tilt sensor not active (switch on)
-
# Codes
Number of diagnostic trouble codes
-
-
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
D Door Courtesy SW
Driver side door courtesy light switch signal / ON or OFF
ON: Driver side door opened
OFF: Driver side door closed
-
D Door Lock Pos SW
Driver side door lock position switch signal / ON or OFF
ON: Driver side door unlocked
OFF: Driver side door locked
-
Door Key SW-Lock
Door key linked lock switch signal / ON or OFF
ON: Driver side door key cylinder turned to lock position
OFF: Driver side door key cylinder not turned
-
D-Door Key SW-UL
Door key linked unlock switch signal / ON or OFF
ON: Driver side door key cylinder turned to unlock position
OFF: Driver side door key cylinder not turned
-
P-Door Courtesy SW
Front passenger side door courtesy light switch signal / ON or OFF
ON: Front passenger side door opened
OFF: Front passenger side door closed
-
P-Door Lock Pos SW
Front passenger side door lock position switch signal / ON or OFF
ON: Front passenger side door unlocked
OFF: Front passenger side door locked
-
Door Lock SW-Lock
Door manual lock switch signal / ON or OFF
ON: Front passenger side door control switch on (LOCK)
OFF: Front passenger side door control switch off
-
Door Unlock SW-Unlock
Door manual unlock switch signal / ON or OFF
ON: Front passenger side door control switch on (UNLOCK)
OFF: Front passenger side door control switch off
-
RL Door Courtesy SW
Rear LH side door courtesy light switch signal / ON or OFF
ON: Rear LH side door opened
OFF: Rear LH side door closed
-
RL-Door Lock Pos SW
Rear LH side door lock position switch signal / ON or OFF
ON: Rear LH side door unlocked
OFF: Rear LH side door locked
-
RR Door Courtesy SW
Rear RH side door courtesy light switch signal / ON or OFF
ON: Rear RH side door opened
OFF: Rear RH side door closed
-
RR-Door Lock Pos SW
Rear RH side door lock position switch signal / ON or OFF
ON: Rear RH side door unlocked
OFF: Rear RH side door locked
-
Back Door Courtesy SW
Back door courtesy light switch signal / ON or OFF
ON: Back door open
OFF: Back door closed
-
Back Door Open SW
ON / OFF
ON: Back door opener switch on
OFF: Back door opener switch off
-
Back Door Open
Permit / Prohibit
PERMIT: Back door open available
PROHIBIT: Back door open unavailable
-
IG SW
ON / OFF
ON: Engine switch is on (IG)
OFF: Engine switch is off
-
ACC SW
ON / OFF
ON: Engine switch on (ACC)
OFF: Engine switch off
-
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform the Active Test allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry&Start / Active Test.
According to the display on intelligent tester, perform the "Active Test".
Entry&Start Tester Display
Test Part
Control Range
Diagnostic Note
Security Indicator
Security indicator
ON / OFF
-
Security Horn*1
Security horn
ON / OFF
-
Security Horn2*2
Theft warning siren (self power siren)
ON / OFF
-
Power For Tilt Sensor*3
Tilt sensor power supply
ON / OFF
-
Power For Intrusion Sensor*3
Intrusion sensor power supply
ON / OFF
-
- HINT:
- *1: w/ Security Horn
- *2: w/ Theft Warning Siren (Self Power Siren)
- *3: w/ Intrusion Sensor