2011-2013 Land Cruiser · Service Manual Drivetrain

INITIALIZATION

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


RESET MEMORY

NOTICE:
  1. Perform the Reset Memory (AT initialization) when replacing the automatic transmission assembly, valve body assembly or any of the shift solenoid valves.
  2. The Reset Memory can be performed only with the intelligent tester.

HINT:
The ECM memorizes the control conditions of the automatic transmission assembly and engine assembly. Therefore, when the automatic transmission assembly, valve body assembly or any of the shift solenoid valves has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Powertrain / ECT / Utility / Reset Memory.

    NOTICE:
    After performing the Reset Memory, be sure to perform the Road Test (Click here) described earlier.

    HINT:
    The ECM learns through the Road Test.

← INITIALIZATION (Sep 2011 – Dec 2011)MONITOR DRIVE PATTERN (Sep 2011 – Dec 2011) →