Home › Engine / Hybrid / EV System › 1GR-FE ENGINE CONTROL › SFI SYSTEM
MIL Circuit
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The MIL (Malfunction Indicator Lamp) is used to indicate the detection of vehicle malfunctions by the ECM. When the ignition switch is turned to ON, power is supplied to the MIL circuit and the ECM provides the circuit ground which illuminates the MIL. The MIL operation can be checked visually. When the ignition switch is first turned to ON, the MIL should be illuminated and should then turn off when the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS. WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK WHETHER MIL IS ILLUMINATED
Perform troubleshooting in accordance with the table below.
Result
Result
Proceed to
MIL remains on
A
MIL does not illuminate
B
B
A
2. CHECK WHETHER MIL TURNS OFF
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Check if DTCs have been stored (Click here ). If DTCs are output, write them down.
Clear the DTCs (Click here ).
Check that the MIL turns off.
OK:
MIL turns off.
NG
OK
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here )
3. CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS)
Disconnect the ECM connector.
Turn the ignition switch to ON.
Check that the MIL is not illuminated.
OK:
MIL is not illuminated.
NG
OK
4. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
Disconnect the ECM connector.
Disconnect the combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for LHD
Tester Connection
Condition
Specified Condition
E8-12 (CHK) or A38-24 (W) - Body ground
Always
10 kΩ or higher
for RHD
Tester Connection
Condition
Specified Condition
E8-12 (CHK) or A52-24 (W) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
5. CHECK THAT MIL IS ILLUMINATED
Check if the MIL is illuminated when the ignition switch is turned to ON.
OK:
MIL illuminates.
NG
OK
6. CHECK THAT ENGINE STARTS
Turn the ignition switch to ON.
Start the engine.
Result
Result
Proceed to
Engine starts
A
Engine does not start*
B
HINT:
*: The GTS cannot communicate with the ECM.
B
A
7. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
Disconnect the ECM connector.
Disconnect the combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for LHD
Tester Connection
Condition
Specified Condition
E8-12 (CHK) - A38-24 (W)
Always
Below 1 Ω
for RHD
Tester Connection
Condition
Specified Condition
E8-12 (CHK) - A52-24 (W)
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK