2011-2013 Land Cruiser · Service Manual Vehicle Interior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use these procedures to troubleshoot the airbag system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Check for DTC (Click here).

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output (for LHD)
      B
      DTC is output (for RHD)
      C


    B.

    C.
    A

    4.WARNING LIGHT CHECK
      NEXT

      5.CHECK DTC (Present and Past DTCs)*
      1. Check for DTC (Click here).

        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      A

      6.DTC CHART
        NEXT

        7.CIRCUIT INSPECTION
          NEXT

          8.REPAIR
            NEXT

            9.CLEAR DTC (Present and Past DTCs)*
              NEXT

              10.CHECK DTC (Present and Past DTCs)*
              1. Check for DTC (Click here).

                Result 
                Result
                Proceed to
                DTC is not output
                A
                DTC is output
                B


              B.
              A

              11.CONFIRMATION TEST
                NEXT

                ← SYSTEM DESCRIPTION (from Sep 2011)HOW TO PROCEED WITH TROUBLESHOOTING (from Jan 2012) →