DATA LIST / ACTIVE TEST
System information · Vehicles built from Sep 2011
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on the intelligent tester, read the Data List.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ACC SW
Engine switch on (ACC)/ON or OFF
ON: Engine switch on (ACC)
OFF: Engine switch off
-
IG SW
Engine switch on (IG)/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Stop Light SW
Stop light switch/ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Start Switch1
Start switch 1/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Start Switch2
Start switch 2/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Steering Unlock Switch
Steering lock condition/ON or OFF
ON: Steering unlocked
OFF: Steering locked
-
Neutral SW/ Clutch SW
Park/neutral position switch (A/T), clutch start switch (M/T)/ON or OFF
ON: Shift lever in P or N (A/T), clutch pedal depressed (M/T)
OFF: Shift lever not in P or N (A/T), clutch pedal released (M/T)
-
Shift P Signal
Shift P position signal/ON or OFF
ON: Shift lever in P
OFF: Shift lever not in P
-
Vehicle Speed Signal
Vehicle speed signal/STOP or RUN
STOP: Vehicle stopped
RUN: Vehicle running
-
Engine Condition
Engine condition/STOP or RUN
STOP: Engine stopped
RUN: Engine running
-
IG1 Relay Monitor(Outside)
IG1 No. 3 relay outer relay monitor/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
IG2 Relay Monitor(Outside)
Integration relay (IG2 relay) outer relay monitor/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
IG1 Relay Monitor(Inside)
IG1 No. 3 relay inner relay monitor/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
IG2 Relay Monitor(Inside)
Integration relay (IG2 relay) inner relay monitor/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
ACC Relay Monitor
ACC relay monitor/ON or OFF
ON: Engine switch on (ACC)
OFF: Engine switch off
-
Latch Circuit
Latch circuit/ON or OFF
ON: Engine switch on (ACC)
OFF: Engine switch off, on (ACC)
-
Starter Request Signal
Starter request signal/ON or OFF
ON: ST relay ON
OFF: ST relay OFF
-
Power Supply Condition
Power supply condition/ALL OFF, ACC ON, IG2 ON, ST ON
ALL OFF: All relays OFF
ACC ON: ACC relay ON
IG2 ON: Integration relay (IG2 relay) ON
ST ON: STSW signal ON
-
ACC Relay Cut Signal
ACC relay cut signal/ON or OFF
ON: Engine cranking
OFF: Engine not cranking
-
Starter Relay Monitor
ST relay monitor/ON or OFF
ON: Engine cranking
OFF: Engine not cranking
-
Communication Smart/Wireless
Communication to certification ECU (smart key ECU assembly)/OK or STOP
OK: Communication
STOP: No communication
-
The Number of DTC
Number of diagnostic trouble codes/Min: 0, Max: 255
-
-
Entry & Start Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Ignition Switch
Engine switch/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Unmatched Vehicle-ID
Key ID/YES or NO
YES: Key ID matches
NO: Key ID differs
-
No Response
No Communication condition between vehicle and electrical key transmitter (response) / Yes or No
Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle
-
Unmatch Code or Form
Code format/YES or NO
YES: Code format matches
NO: Code format differs
-
Key Low Battery
Key battery conditions/Yes or No
Yes: Key battery voltage low
No: Key battery voltage normal
-
#Codes
Number of diagnostic trouble codes/Min: 0, Max: 255
-
-
ID Code Difference(Resp)
ID code/YES or NO
YES: ID code matches
NO: ID code differs
-
C Code Difference
Challenge code/YES or NO
YES: Challenge code matches
NO: Challenge code differs
-
Engine Start Condition
Engine start condition by certification ECU (smart key ECU assembly)/OK or NG
OK: Engine start permitted
NG: Engine start prohibited
-
S Code Check
S code certification result/NG or OK
OK: S code certification result normal
NG: S code certification result abnormal
-
L Code Check
L code certification result/NG or OK
OK: L code certification result normal
NG: L code certification result abnormal
-
Ignition Available Area
Key area where engine start is possible/All or Front
All: All areas
Front: Front only
-
| PERFORM ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Main Body Tester Display
Test Part
Control Range
Diagnostic Note
Indicator for Lighting
Indicator illumination
ON/OFF
-
Indicator Condition
Indicator light illumination pattern
Green/Amber/No Sig
-
P Supply for Steering Lock
Steering lock ECU power supply
ON/OFF
-
Entry & Start Tester Display
Test Part
Control Range
Diagnostic Note
Fr-Seat Inside Transmitter
Indoor key antenna (for front)
ON/OFF
-
Rr-Seat Inside Transmitter
Indoor key antenna (for rear1)
ON/OFF
-
Inside Trunk/Backdoor Transmitter
Indoor key antenna (for rear2)
ON/OFF
-
Outside Trunk/Backdoor Transmitter
Electrical key antenna
ON/OFF
-