2011-2013 Land Cruiser · Service Manual Steering

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from Sep 2011


GENERAL DESCRIPTION
  1. The Variable Gear Ratio Steering (VGRS) system controls the steering angle in accordance with vehicle speed. The system is controlled by the steering control ECU which operates the steering actuator mounted on the steering intermediate shaft. The operating angle of the steering actuator is added to the steering angle of the pinion gear in order to vary the turning angle of the front wheels in accordance with vehicle speed.

  2. When the VGRS system is operating normally, the steering wheel can be turned approximately 2.7 turns from lock to lock, with the engine running and the vehicle stopped.

  3. If a malfunction occurs in the VGRS system, steering actuator operation will immediately stop and the input and output shafts will be directly connected to enable the conventional steering mechanism to operate, maintaining the steering function (fail-safe). At the same time, the master warning light will come on to inform the driver of the malfunction.


FUNCTIONS OF COMPONENTS
  1. Functions of VGRS system components

    Component
    Function
    Steering Control ECU
    Calculates the steering gear ratio based on vehicle speed signals, steering wheel angle and steering wheel angle speed. Drives the steering actuator based on calculation results of steering cooperative control received from the skid control ECU, and steering gear ratio control.
    Steering Actuator
    Drives the motor using the output current from the steering control ECU to change the output shaft angle.
    Rotation Angle Sensor
    (Built into Steering Actuator)
    Outputs the motor rotation angle to the steering control ECU.
    Steering Angle Sensor
    Outputs the steering wheel angle to the steering control ECU.
    Master Warning Light
    Located in the combination meter. Comes on in accordance with system conditions to inform the driver of system malfunctions.
    Multi-information Display
    Located in the combination meter. Displays a warning message to inform the driver of system malfunctions.

← SYSTEM DIAGRAM (from Sep 2011)HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011) →