2011-2013 Land Cruiser · Service Manual Steering

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK DTC (Using Tester)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus: Chassis / VGRS / DTC.

  5. Read the DTCs.


CLEAR DTC (Using Tester)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG) (do not start the engine).

  3. Turn the tester on.

  4. Enter the following menus: Chassis / VGRS / DTC.

  5. Clear the DTCs.


CHECK DTC (Using SST Check Wire)
H102392E79

HINT:
The master warning light comes on in diagnostic mode.

  1. Using SST check wire, connect terminals 13 (TC) and 4 (CG) of the DLC3.

    SST
    09843-18040  

  2. Turn the engine switch on (IG).

  3. "DIAG VGRS" is displayed on the multi-information display and the system starts searching for a malfunction.

  4. C175641
    If the system is normal, "DIAG VGRS OK" is displayed.

  5. C175640
    If the system has a malfunction, "DIAG VGRS xx" is displayed ("xx" is a 2-digit DTC).


CLEAR DTC (Using SST Check Wire)
H102392E79
  1. Turn the engine switch on (IG).

  2. Using SST check wire, connect and disconnect terminals 13 (TC) and 4 (CG) of the DLC3 4 times within 8 seconds.

    SST
    09843-18040  

  3. Disconnect SST check wire from the DLC3.

    NOTICE:
    As the stored yaw rate and G sensor value will be cleared by the above operation, it is necessary to obtain the yaw rate and G sensor zero point.

  4. Turn the engine switch off.

    HINT:
    If the problem still exists, DTCs may not be cleared.

  5. Obtain the yaw rate and G sensor zero point (Click here).

← DTC CHECK / CLEAR (Sep 2011 – Dec 2011)FREEZE FRAME DATA (from Sep 2011) →