2011-2013 Land Cruiser · Service Manual Drivetrain

Pattern Select Switch Power Mode Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The ECM memory contains the programs for the normal and power shift patterns and lock-up pattern.
By following the programs corresponding to the signals from the pattern select switch, the park/neutral position switch and other various sensors, the ECM switches the solenoid valves on and off, and controls the transmission gear change and the lock-up clutch operation.

WIRING DIAGRAM

C176075E09

INSPECTION PROCEDURE

When the pattern select (PWR) switch is pushed, switch contact is made and power mode is selected. To cancel power mode, push the pattern select (PWR) switch once again.

1. INSPECT PATTERN SELECT (PWR) SWITCH

  1. C238423E06
    Remove the suspension control switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    16 (P) - 20 (E)
    Pattern select (PWR) switch on
    Below 1 Ω
    16 (P) - 20 (E)
    Pattern select (PWR) switch off
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Suspension Control Switch)



NG
REPLACE PATTERN SELECT (PWR) SWITCH (SUSPENSION CONTROL SWITCH) (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (PATTERN SELECT (PWR) SWITCH - BODY GROUND)

  1. C227138E01
    Disconnect the suspension control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    V4-20 (E) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Suspension Control Switch)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (PATTERN SELECT (PWR) SWITCH - ECM)
C197708E40
  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A38-51 (PWR) - Body ground
    Pattern select (PWR) switch on
    Below 1 Ω
    A38-51 (PWR) - Body ground
    Pattern select (PWR) switch off
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Pattern Select Switch Power Mode Circuit (Sep 2011 – Dec 2011)Pattern Select Switch 2nd Start Mode Circuit (Sep 2011 – Dec 2011) →