After checking that no DTC is output for the VGRS system, perform the following procedure.
1. CHECK STEERING WHEEL POSITION
Turn the steering wheel from lock to lock at a speed of approximately 90°/sec. Check the steering wheel angles between the left and right.
Result
Result
Proceed to
The steering wheel is off-center
A
The steering wheel is centered
B
HINT:
If turning the steering wheel quickly while driving at low speeds, the steering angle may differ between the left and right, or the steering wheel may become off-center. However, this is not a malfunction.
B
VGRS SYSTEM IS NORMAL
A
2. CHECK STEERING EFFORT
Start the engine.
Turn the steering wheel.
Measure the steering effort.
Standard steering effort:
Below 6.9 N*m (70 kgf*cm, 61 in.*lbf)
HINT:
After completing the inspection or repair, attempt to simulate the problem and then read the Data List again to confirm that the problem does not occur.
Result
Result Result
Proceed to
OK
A
NG (for 1VD-FTV with DPF)
B
NG (except 1VD-FTV with DPF)
C
B
GO TO POWER STEERING SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)
C
GO TO POWER STEERING SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)
Adjust the tie-rod ends within the specified values so that the tire angles are the same between the left and right when the steering wheel is turned from lock to lock.