2011-2013 Land Cruiser · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Install the switch to the manual valve shaft.

  1. C175583
    Temporarily install the bolt.

  1. C175584E01
    Install a new lock washer and the nut.

    Torque:
    6.9 N*m{ 70 kgf*cm , 61 in.*lbf }

  1. C175585
    Temporarily install the control shaft lever RH.

  1. C172409E01
    Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.

  1. Remove the control shaft lever RH.

  1. D025795E10
    Align the groove with the neutral basic line.

  1. Hold the switch in the position described above and tighten the bolt.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. C177424
    Using a screwdriver, bend the tabs of the lock washer.

  1. Install the transmission control rod bush and collar to the transmission control shaft lever RH.

  1. C175585
    Install the transmission control shaft lever RH with the spring washer and nut.

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }

  1. Connect the switch connector.


2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

C170828
  1. Connect the shifting rod to the transmission control shaft lever RH with the pin.

  1. Install a new clip.


3. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.

  1. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to S.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves rearward after moving the shift lever to R.
    If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.


4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(Click here)
← ADJUSTMENT (from Sep 2011)INSTALLATION (from Jan 2012) →