2011-2013 Land Cruiser · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ DPF)

  1. A271059
    Disconnect the air fuel ratio sensor connector.

  1. A267196
    Disconnect the 2 air hoses.

  1. Disconnect the exhaust gas temperature sensor connector and detach the clamp.

  1. Remove the 2 bolts and 2 compression springs and disconnect the front exhaust pipe assembly from the center exhaust pipe assembly.

  1. Remove the 3 nuts and front exhaust pipe.

  1. Remove the 2 gaskets from the front exhaust pipe assembly.


2. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

C170828
  1. Remove the clip and pin, and disconnect the shifting rod from the transmission control shaft lever RH.


3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Disconnect the switch connector.

  1. C175585
    Remove the nut, spring washer and transmission control shaft lever RH.

  1. Remove the collar and transmission control rod bush from the transmission control shaft lever RH.

  1. C177424
    Using a screwdriver, bend the tabs of the lock washer.

  1. C175584
    Remove the lock nut and lock washer.

  1. C175583
    Remove the bolt and switch.

    HINT:
    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →