2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REPLACEMENT

Removal / installation · Vehicles built from Sep 2011


1. REMOVE REAR WIPER BLADE

  1. B283532
    Detach the claw as shown in the illustration.

  1. B283533
    Remove the rear wiper blade as shown in the illustration.

    NOTICE:
    Do not fold the wiper arm with the wiper blade removed. The arm tip may damage the windshield surface.


2. REMOVE REAR WIPER RUBBER

  1. E057398
    Detach the head part (large side) of the rear wiper rubber from the rear wiper blade.

  1. B283534E01
    Remove the rear wiper rubber in the direction indicated by the arrow in the illustration.
    Text in Illustration 
    *a
    Head Part (Large Side)

    NOTICE:
    Do not pull out the wiper rubber forcibly. Doing so will deform the backing plate or damage the blade claw.

  1. Remove the 2 backing plates from the rear wiper rubber.


3. INSTALL REAR WIPER RUBBER

  1. I030020E05
    Install the 2 backing plates to the rear wiper rubber.
    Text in Illustration 
    *a
    Curved

    NOTICE:
    Install the backing plates facing the proper direction.

  1. B283535E01
    Install the rear wiper rubber to the claw of the wiper blade in the direction indicated by the arrow in the illustration.
    Text in Illustration 
    *a
    Head Part (Large Side)

    HINT:
    Install the rear wiper rubber so that the head part (large side) of the wiper rubber faces the arm axle side.

  1. E219600
    Attach the head part (large side) of the rear wiper rubber to the rear end side claw of the rear wiper blade.

    NOTICE:
    Push the rear wiper blade into the grooves of the rear wiper rubber to attach them completely.


4. INSTALL REAR WIPER BLADE

  1. B283536
    Attach the claw to install the rear wiper blade.

← COMPONENTS (from Sep 2011)COMPONENTS (from Sep 2011) →