2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Navigation ECU Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This is the power source circuit to operate the display and navigation module display.

WIRING DIAGRAM

E183491E04

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION MODULE DISPLAY POWER SOURCE)

  1. E194871E08
    Disconnect the F64 display and navigation module display connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F64-10 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F64-1 (+B1) - F64-10 (GND1)
    Always
    11 to 14 V
    F64-2 (ACC) - F64-10 (GND1)
    Engine switch on (ACC)
    11 to 14 V
    F64-3 (IG) - F64-10 (GND1)
    Engine switch on (IG)
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Display and Navigation Module Display)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Microphone Circuit between Microphone and Navigation ECU (Sep 2011 – Dec 2011)PRECAUTION (Sep 2011 – Dec 2011) →