2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL REAR WIPER MOTOR ASSEMBLY

  1. B181333
    Temporarily install the rear wiper motor assembly with the 3 bolts.

  1. Tighten the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.


2. INSTALL REAR WIPER MOTOR GROMMET

  1. E156014E01
    Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.


3. INSTALL REAR WIPER ARM
  1. Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.

  1. B190077E01
    Clean the wiper pivot serration with a wire brush.

  1. E156015E01
    Set the head of the blade on the defogger line.

  1. Install the nut and rear wiper arm.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Close the cover.


4. INSTALL BACK DOOR GARNISH

  1. B181329
    Attach the 14 clips to install the back door garnish.


5. INSTALL DOOR OPENING SWITCH SUB-ASSEMBLY (for Face to Face Seat Type)

  1. B186429
    Attach the 2 claws to install the power back door main switch.


6. INSTALL NO. 2 BACK DOOR SERVICE HOLE COVER (for Face to Face Seat Type)

  1. B186428
    Connect the connector.

  1. Attach the 4 claws to install service hole cover.


7. INSTALL ASSIST GRIP (for Face to Face Seat Type)

  1. B188374
    Install the assist grip with the 2 screws.


8. INSTALL BACK DOOR SIDE GARNISH LH

  1. B181327
    Attach the 3 clips to install the back door side garnish.


9. INSTALL BACK DOOR SIDE GARNISH RH

HINT:
Use the same procedures described for the LH side.


10. INSTALL CENTER BACK DOOR GARNISH

  1. B181326
    Attach the 5 clips and 2 claws to install the back door garnish.

← INSPECTION (from Sep 2011)INSTALLATION (from Jan 2012) →