INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT CHARCOAL CANISTER |
Visually check the canister for cracks or damage.

Blow compressed air of 4.9 kPa (50 gf/cm2, 0.71 psi) into port A and check that air flows without resistance from port B and port C.
If the result is not as specified, replace the canister.
Apply a vacuum of 1.96 kPa (20 gf/cm2, 0.28 psi) to port A. Check that the vacuum does not decrease when ports B and C are closed, and check that the vacuum does not decrease when port B is released.
If the result is not as specified, replace the canister.
| CLEAN FILTER IN CANISTER |
Clean the filter by blowing compressed air of 4.9 kPa (50 gf/cm2, 0.71 psi) into port A while holding port B closed.

- NOTICE:
- Do not attempt to wash the canister.
