INSPECTION
Inspection · Vehicles built from Jan 2012
| INSPECT CHARCOAL CANISTER |
Visually check the canister for cracks or damage.

Text in Illustration *1
Port A
*2
Port B
*3
Port C


Air
Blow compressed air at 5 kPa (0.05 kgf/cm2, 0.7 psi) into port A and check that air flows without resistance from port B and port C.
If the result is not as specified, replace the canister.
Apply a vacuum of 2 kPa (0.02 kgf/cm2, 0.3 psi) to port A. Check that the vacuum does not decrease when ports B and C are closed, and check that the vacuum does not decrease when port B is released.
If the result is not as specified, replace the canister.
| CLEAN FILTER IN CANISTER |
Clean the filter by blowing compressed air at 5 kPa (0.05 kgf/cm2, 0.7 psi) into port A while holding port B closed.

Text in Illustration *1
Port A
*2
Port B


Air
- NOTICE:
- Do not attempt to wash the canister.
