2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Illumination Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

Power is supplied to the radio receiver assembly illumination when the light control switch is in the tail or head position.

WIRING DIAGRAM

E196649E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK ILLUMINATION
  1. Check if the illumination for the radio receiver assembly, heater control switch or others (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the head or tail position.

    Result 
    Result
    Proceed to
    Illumination comes on for all components except radio receiver assembly.
    A
    No illumination comes on (radio receiver assembly, hazard switch, heater control switch, etc.).
    B



B
GO TO LIGHTING SYSTEM (Click here)
A


2. CHECK HARNESS AND CONNECTOR (BATTERY AND BODY GROUND - RADIO RECEIVER ASSEMBLY)

  1. E176654E64
    Disconnect the F56 radio receiver assembly connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F56-3 (ILL+) - Body ground
    Light control switch tail or head
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F56-17 (ILL-) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Radio Receiver Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Steering Pad Switch Circuit (from Jan 2012)Illumination Circuit (from Jan 2012) →