2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Radio Receiver Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM

E141050E19

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT RADIO RECEIVER ASSEMBLY

  1. E151935E43
    Disconnect the F1 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F1-20 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F1-1 (B) - F1-20 (GND)
    Always
    11 to 14 V
    F1-11 (ACC) - F1-20 (GND)
    Engine switch on (ACC)
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Radio Receiver Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Multi-media Interface ECU Communication Error (from Jan 2012)Radio Receiver Power Source Circuit (from Jan 2012) →