2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
*: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.CONNECT INTELLIGENT TESTER TO DLC3

        HINT:
        If the display indicates a communication fault with the tester, inspect the DLC3.

      NEXT

      4.CHECK DTC AND FREEZE FRAME DATA*

        HINT:
        Record or print DTCs and freeze frame data if necessary.

      NEXT

      5.CLEAR DTC AND FREEZE FRAME DATA*
        NEXT

        6.VISUAL INSPECTION
          NEXT

          7.SET CHECK MODE DIAGNOSIS*
          1. Refer to the check mode procedure (Click here).

          NEXT

          8.CONFIRM PROBLEM SYMPTOMS

            HINT:
            If the engine does not start, first perform the "Check DTC" procedures and "Basic Inspection" procedures below.

            Result 
            Result
            Proceed to
            Malfunction occurs
            A
            Malfunction does not occur
            B

          B.
          A

          9.CHECK DTC*
            Result 
            Result
            Proceed to
            Trouble code
            A
            No trouble code
            B

          B.
          A

          10.REFER TO DTC CHART
            NEXT

            11.BASIC INSPECTION
              Result 
              Result
              Proceed to
              Malfunctioning parts not confirmed
              A
              Malfunctioning parts confirmed
              B

            B.
            A

            12.REFER TO PROBLEM SYMPTOMS TABLE

              HINT:
              Refer to the Problem Symptoms Table (Click here).

              Result 
              Result
              Proceed to
              Malfunctioning circuit confirmed
              A
              Malfunctioning parts confirmed
              B

            B.
            A

            13.CHECK ECM POWER SOURCE CIRCUIT
              NEXT

              14.CONDUCT CIRCUIT INSPECTION
                Result 
                Result
                Proceed to
                Malfunction not confirmed
                A
                Malfunction confirmed
                B

              B.
              A

              15.CHECK FOR INTERMITTENT PROBLEMS
                NEXT

                16.PARTS INSPECTION
                  NEXT

                  17.IDENTIFY PROBLEM
                    NEXT

                    18.ADJUST AND/OR REPAIR
                      NEXT

                      19.CONFIRMATION TEST
                        NEXT

                        ← HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011)CHECK FOR INTERMITTENT PROBLEMS (Sep 2011 – Dec 2011) →