2011-2013 Land Cruiser · Service Manual Brake

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG
  1. Temporarily install the bleeder plug to the disc brake caliper.

    HINT:
    The bleeder plug will be tightened to a torque specification in the "Bleed Brake Line" procedure.


2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

3. INSTALL PISTON SEAL
  1. Apply lithium soap base glycol grease to 4 new piston seals.

  1. C172159
    Install the 4 piston seals to the disc brake caliper.


4. INSTALL FRONT DISC BRAKE PISTON

  1. C172160E01
    Apply lithium soap base glycol grease to the 4 front disc brake pistons and 4 new cylinder boots.

  1. Install the 4 cylinder boots to the 4 front disc brake pistons.

  1. Install the 4 pistons into the front disc brake caliper.

    NOTICE:
    Do not forcibly install the piston into the disc brake caliper.


5. INSTALL CYLINDER BOOT

  1. C172161E01
    Install one side of each of the 4 cylinder boots to the front disc brake caliper.

    NOTICE:
    1. Install the cylinder boot securely to the grooves of the cylinder and piston.
    2. Do not damage the cylinder boot.


6. INSTALL FRONT DISC BRAKE PISTON SET RING
  1. Install the 4 set rings.

← INSPECTION (from Sep 2011)INSTALLATION (from Sep 2011) →