2011-2013 Land Cruiser · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Sep 2011


1. INSTALL TRANSMISSION WIRE
  1. Coat the O-ring of the transmission wire connector with ATF.

  1. C125286
    Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. C155913
    Connect the transmission wire connector.

    HINT:
    Push up the lever until the claw of the transmission wire connector makes a connection sound.


2. CONNECT TRANSMISSION WIRE

  1. C125285E02
    Connect the 7 connectors to the solenoid valves.

  1. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

    Torque:
    for bolt A:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }
    for bolt B:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    12 mm (0.472 in.) for bolt A

    36 mm (1.42 in.) for bolt B


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

D028692E01
  1. Coat a new O-ring with ATF and install it to the oil strainer.

  1. Install the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

C153314E01

NOTICE:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install a new gasket and the oil pan with the 20 bolts.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf }


5. ADD AUTOMATIC TRANSMISSION FLUID
  1. Add automatic transmission fluid (Click here).

← INSPECTION (from Sep 2011)COMPONENTS (from Sep 2011) →