2011-2013 Land Cruiser · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Sep 2011


1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

D027914E04
  1. Install the spring and check ball body.

  1. C157293E01
    Insert the pin of the manual valve into the hole of the manual valve lever.

  1. C157292E01
    Install the transmission valve body with the 19 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.

    36 mm (1.42 in.) for bolt A
    25 mm (0.984 in.) for bolt B

  1. Install the detent spring and detent spring cover with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


2. CONNECT TRANSMISSION WIRE

  1. C125285E02
    Connect the 7 connectors to the solenoid valves.

  1. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

    Torque:
    for bolt A:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }
    for bolt B:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    12 mm (0.472 in.) for bolt A

    36 mm (1.42 in.) for bolt B


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

D028692E01
  1. Coat a new O-ring with ATF and install it to the oil strainer.

  1. Install the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

C153314E01

NOTICE:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install a new gasket and the oil pan with the 20 bolts.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf }


5. RESET MEMORY
for 1GR-FE: (Click here)
for 2UZ-FE: (Click here)

6. ADD AUTOMATIC TRANSMISSION FLUID
  1. Add automatic transmission fluid (Click here).

← REASSEMBLY (from Sep 2011)COMPONENTS (from Sep 2011) →