When an entry lock switch is pressed and held for approximately 3 seconds: 1) the main body ECU receives a signal via the driver side door ECU, 2) the main body ECU transmits a signal to all the power window regulator motor, and 3) all the power window motors are activated to close the windows.
INSPECTION PROCEDURE
1. CHECK BASIC FUNCTION (ENTRY & START SYSTEM (for Entry Function))
Check that the entry lock switch operates (Click here).
OK:
Entry lock switch can lock all the doors.
NG
GO TO ENTRY & START SYSTEM (for Entry Function) (Click here)
OK
REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)