DISASSEMBLY
Removal / installation · Vehicles built from Sep 2011
| 1. REMOVE AUTOMATIC TRANSMISSION CASE O-RING |
Remove the O-ring from the oil pump assembly.

| 2. FIX OIL PUMP ASSEMBLY |
Place the oil pump body on the torque converter.

| 3. REMOVE CLUTCH DRUM OIL SEAL RING |
Remove the 3 oil seal rings.

| 4. REMOVE STATOR SHAFT ASSEMBLY |
Remove the 14 bolts, and then remove the stator shaft from the oil pump body.

| 5. REMOVE FRONT OIL PUMP BODY O-RING |
Remove the O-ring from the oil pump body.

Remove the oil pump body from the torque converter clutch.
| 6. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
Using a dial indicator, measure the inside diameter of the oil pump body bush.

- Maximum inside diameter:
- 38.188 mm (1.50 in.)
- If the inside diameter is more than the maximum, replace the oil pump body sub-assembly.
| 7. INSPECT STATOR SHAFT ASSEMBLY |
Using a dial indicator, measure the inside diameter of the stator shaft bush.

- Maximum inside diameter:
- Front side:
- 21.577 mm (0.849 in.)
- Rear side:
- 32.08 mm (1.26 in.)
- If the inside diameter is grater than the maximum, replace the stator shaft assembly.
| 8. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
Push the driven gear to one side of the body.

Using a feeler gauge, measure the body clearance.
- Standard body clearance:
- 0.10 to 0.17 mm (0.00394 to 0.00669 in.)
- Maximum body clearance:
- 0.17 mm (0.00669 in.)
- If the body clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly.
Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.

- Standard tip clearance:
- 0.070 to 0.150 mm (0.00276 to 0.00591 in.)
- Maximum tip clearance:
- 0.150 mm (0.00591 in.)
- If the tip clearance is more than the maximum, replace the drive gear, driven gear or pump body assembly.
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.

- Standard side clearance:
- 0.02 to 0.05 mm (0.000787 to 0.00197 in.)
- Maximum side clearance:
- 0.05 mm (0.00197 in.)
- HINT:
- There are 5 different thicknesses for the drive and driven gears.
- Drive and Driven Gears Thickness:
Mark
Thickness
0
10.74 to 10.749 mm (0.42283 to 0.42319 in.)
1
10.75 to 10.759 mm (0.42323 to 0.42358 in.)
2
10.76 to 10.77 mm (0.42362 to 0.42401 in.)
3
10.771 to 10.78 mm (0.42405 to 0.42441 in.)
4
10.781 to 10.79 mm (0.42445 to 0.42480 in.)
| 9. REMOVE FRONT OIL PUMP DRIVE GEAR |
![]() ![]() |
| 10. REMOVE FRONT OIL PUMP DRIVEN GEAR |
![]() ![]() |
| 11. REMOVE FRONT OIL PUMP OIL SEAL |
Using a screwdriver, pry out the oil seal.

- NOTICE:
- Be careful not to damage the bushing and oil pump body.


