2011-2013 Land Cruiser · Service Manual Drivetrain

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL FRONT OIL PUMP OIL SEAL

  1. D027961E06
    Using SST and a hammer, tap in a new oil seal.
    SST
    09350-30020   (09351-32140)

    HINT:
    The oil seal end should be flush with the outer edge of the pump body.

  1. Coat the lip of the oil seal with MP grease.


2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
  1. Place the oil pump body on the torque converter clutch.


3. INSTALL FRONT OIL PUMP DRIVEN GEAR

  1. D027959E01
    Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

  1. D027958E01
    Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.


5. INSTALL FRONT OIL PUMP BODY O-RING

  1. D027963E02
    Coat a new O-ring with ATF and install it to the oil pump body.


6. INSTALL STATOR SHAFT ASSEMBLY

  1. D027953E01
    Align the stator shaft with the bolt holes.

  1. Install the 14 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }


7. INSTALL CLUTCH DRUM OIL SEAL RING

  1. D027952E06
    Coat 3 new oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together with an overlap distance of 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

    NOTICE:
    Do not excessively widen the ring.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.


8. INSPECT OIL PUMP DRIVE GEAR ROTATION

D027962E01
  1. Place the oil pump body on the torque converter clutch.

  1. Check that the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter.


9. INSTALL AUTOMATIC TRANSMISSION CASE O-RING

  1. D027950E03
    Coat a new O-ring with ATF and install it to the oil pump assembly.

← INSPECTION (from Sep 2011)PRECAUTION (from Jan 2012) →