2011-2013 Land Cruiser · Service Manual Drivetrain

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)

C159421E25
  1. Measure the resistance according to the value(s) in the table below.

    HINT:
    If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

    Standard Resistance:
    Tester Connection
    ATF Temperature
    Specified Condition
    1 (OT-) - 9 (OT+)
    10°C (50°F)
    5 to 8 kΩ
    1 (OT-) - 9 (OT+)
    25°C (77°F)
    2.5 to 4.5 kΩ
    1 (OT-) - 9 (OT+)
    110°C (230°F)
    0.22 to 0.28 kΩ
    2 (OT2-) - 10 (OT2+)
    10°C (50°F)
    5 to 8 kΩ
    2 (OT2-) - 10 (OT2+)
    25°C (77°F)
    2.5 to 4.5 kΩ
    2 (OT2-) - 10 (OT2+)
    110°C (230°F)
    0.22 to 0.28 kΩ

    If the result is not as specified, replace the transmission wire.

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →