2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK ILLUMINATION TIME OF GLOW INDICATOR LIGHT

  1. Check the light illumination duration.

    1. Turn the ignition switch to ON and measure the light illumination time.

      Light illumination time:
      See graph.


      A272168E01
      Text in Illustration 
      *A
      w/ DPF
      *B
      w/o DPF
      *1
      Seconds
      *2
      Engine Coolant Temperature
      °C (°F)
      *3
      Light Illumination Time
      -
      -
      1. If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug assembly and glow relay.

      HINT:
      Actual light illumination duration may vary slightly from the graph.

    2. Turn the ignition switch off.


CHECK PRE-HEATING

  1. Inspect the pre-heating time.

    1. Turn the ignition switch to ON. Measure how long it takes for the battery voltage to be applied to the glow plugs.

      Standard Pre-Heating Time:
      Engine Coolant Temperature
      Specified Condition
      40°C (104°F) or higher
      1 second
      Below 40°C (104°F)
      See graph*
      (Maximum: 21 seconds)

      HINT:
      *: The pre-heating time changes depending on the battery voltage.


      A272529E01
      Text in Illustration 
      *1
      Seconds
      *2
      Battery Voltage
      (V)
      *3
      After Glow Time
      -
      -
      1. If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug assembly and glow relay.

    2. Turn the ignition switch off.


CHECK AFTER GLOW TIME

  1. A182350E01
    Remove the No. 1 glow relay (GLOW 1) from the engine room relay block.

  1. Remove the No. 2 glow relay (GLOW 2) from the engine room relay block.

  1. After the engine starts, measure the time duration that battery voltage remains present.

    Standard After Glow Time:
    Tester Connection
    Condition
    Specified Condition
    2 - Body ground
    After engine starts
    Refer to graph below
    2 - Body ground


    A272169E01
    Text in Illustration 
    *A
    w/ DPF
    *B
    w/o DPF
    *1
    Seconds
    *2
    Engine Coolant Temperature
    °C (°F)
    *3
    After Glow Time
    -
    -
    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug assembly and glow relay.

← ON-VEHICLE INSPECTION (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →