REMOVAL
Removal / installation · Vehicles built from Sep 2011
| 1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH |
![]() ![]() |
Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.
| 2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH |
- HINT:
- Use the same procedures described for the LH side.
| 3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 10 bolts and under cover.

| 4. DRAIN ENGINE COOLANT |
- CAUTION:
- Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.
Loosen the radiator drain cock plug.
Remove the radiator reservoir cap to drain the coolant in the radiator.
Loosen the oil filter bracket drain cock plug to drain the coolant in the engine.


Tighten the radiator drain cock plug by hand.
Tighten the oil filter bracket drain cock plug.

- Torque:
- 13 N*m{ 133 kgf*cm , 10 ft.*lbf }
| 5. DRAIN ENGINE OIL |
Remove the 2 bolts and No. 2 engine under cover seal from the No. 2 engine under cover.

Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
- Torque:
- 38 N*m{ 387 kgf*cm , 28 ft.*lbf }
| 6. REMOVE OIL COOLER ASSEMBLY |
Remove the 2 bolts, 2 nuts and oil cooler.

Remove the 2 O-rings and oil cooler gasket.


