REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
REMOVE CENTER BACK DOOR GARNISH
|
 |
- Detach the 5 clips and 2 claws, and remove the back door garnish.
| 3.
REMOVE BACK DOOR SIDE GARNISH LH
|
 |
- Detach the 3 clips and remove the back door side garnish.
| 4.
REMOVE BACK DOOR SIDE GARNISH RH
|
 |
- HINT:
- Use the same procedures described for the LH side.
| 5.
REMOVE ASSIST GRIP (for Face to Face Seat Type)
|
 |
- Remove the 2 screws and assist grip.
| 6.
REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER (for Face to Face Seat Type)
|
 |
- Using a screwdriver, detach the 4 claws and remove the back door service hole cover.
Disconnect connector.
| 7.
REMOVE DOOR OPENING SWITCH SUB-ASSEMBLY (for Face to Face Seat Type)
|
 |
- Detach the 2 claws and remove the door opening switch sub-assembly.
| 8.
REMOVE BACK DOOR TRIM PANEL ASSEMBLY
|
 |
- Remove the 4 bolts.
Detach the 16 clips and remove the back door trim panel.
| 9.
REMOVE REAR HEADER SPEAKER ASSEMBLY |
 |
- HINT:
- Use the same procedure as for the opposite side.
- Remove the 3 screws.
Disconnect the connector and remove the rear header speaker assembly.