2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011


INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
  1. Disconnect the VSV connector.

  1. A085583E09
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    37 to 44 Ω
    1 - Body ground
    Always
    1 MΩ or higher
    2 - Body ground

    If the result is not as specified, replace the vacuum switching valve assembly.

  1. Check the VSV operation.

    1. A163863E01
      When applying vacuum to port E, check that air is sucked into the filter.

    2. A163864E02
      Apply battery voltage to the connector, and check the VSV operation.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      When applying vacuum to port F, check that air is sucked into port E

      If the result is not as specified, replace the vacuum switching valve assembly.

  1. Connect the VSV connector.

← INSTALLATION (from Jan 2012)COMPONENTS (Sep 2011 – Dec 2011) →