2011-2013 Land Cruiser · Service Manual Drivetrain

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL INPUT SHAFT FRONT BEARING

C171236E01
  1. Using SST and a press, install the input shaft front bearing to the input shaft.

    SST
    09316-20011  

    HINT:
    Make sure that the groove of the bearing faces the correct direction as shown in the illustration.


2. INSTALL FRONT BEARING SHAFT SNAP RING

C171237
  1. Select a new snap ring that will allow minimum clearance.

    Standard Clearance:
    0.1 mm (0.00393 in.) or less

    Snap Ring Thickness:
    Part No.
    Thickness
    Mark
    90520-45003
    2.50 to 2.55 mm
    (0.0984 to 0.100 in.)
    A
    90520-45004
    2.55 to 2.60 mm
    (0.100 to 0.102 in.)
    B
    90520-45005
    2.60 to 2.65 mm
    (0.102 to 0.104 in.)
    C
    90520-45006
    2.65 to 2.70 mm
    (0.104 to 0.106 in.)
    D
    90520-45007
    2.70 to 2.75 mm
    (0.106 to 0.108 in.)
    E
    90520-45008
    2.75 to 2.80 mm
    (0.108 to 0.110 in.)
    F

  1. C174274
    Using a snap ring expander, install the snap ring to the input shaft.


3. INSTALL INPUT SHAFT BEARING
  1. Apply MP grease to the 12 roller bearings.

  1. Install the 12 roller bearings into the input shaft.

← INSPECTION (from Sep 2011)COMPONENTS (from Sep 2011) →