2011-2013 Land Cruiser · Service Manual Power Source / Network

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE GENERATOR PULLEY

A163050E01
SST
09820-63011   (09820-06010, 09820-06021)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06021

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured on the rotor shaft.

  1. A163051E01
    Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.

  1. A163052E01
    To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove the generator from SST 2.

  1. A163053E01
    Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the pulley nut and pulley.


2. REMOVE GENERATOR REAR END COVER

A163054
  1. Place the generator on the pulley.

  1. Remove the 3 nuts and rear end cover.


3. REMOVE TERMINAL INSULATOR

  1. A163055
    Remove the terminal insulator from the generator rectifier end frame.


4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

A163056
  1. Remove the 2 screws and brush holder.


5. REMOVE GENERATOR COIL ASSEMBLY

A163057
  1. Remove the 4 bolts.

  1. A163058E01
    Using SST, remove the coil.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)


6. REMOVE GENERATOR ROTOR ASSEMBLY

A163059
  1. Remove the generator washer and generator rotor.


7. REPLACE GENERATOR DRIVE END FRAME BEARING

  1. A163066
    Remove the 4 screws and retainer plate.

  1. A163067E01
    Using SST and a hammer, tap out the bearing.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

  1. A163068E01
    Using SST and a press, press in a new bearing.
    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)

  1. A163066
    Install the retainer plate with the 4 screws.

    Torque:
    2.3 N*m{ 23 kgf*cm , 20 in.*lbf }

← REMOVAL (from Jan 2012)DISASSEMBLY (from Jan 2012) →