2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL FAN & GENERATOR V BELT

  1. A174363E01
    While turning the belt tensioner counterclockwise, align the holes, and then insert a bar of φ6 mm (0.236 in.) into the holes to fix the belt tensioner in place.

  1. Install the fan and generator V belt.

    HINT:
    A151277E01
    If it is hard to install the fan and generator V belt, perform the following procedures.
    1. Put the fan and generator V belt on all parts except the vane pump, as shown in the illustration.
    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the fan and generator V belt on the vane pump.

  1. While turning the belt tensioner counterclockwise, remove the bar.


2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Install the engine under cover with the 10 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Push in the clip indicated by the arrow in the illustration to install the fender splash shield.

  1. Install the 3 bolts and screw.

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →