2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P0106 Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

Refer to DTC P0105 (Click here).
P0106 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
After warming up engine, idle engine for 10 seconds or more, then drive vehicle under load (accelerator opening angle 10% or more) with engine speed at 2500 rpm or less for 10 seconds
When either of the following conditions is met (2 trip detection logic):
(a) The manifold absolute pressure output is 3.3 V or more for 10 seconds when idling the engine after warming it up.
(b) The manifold absolute pressure sensor output is 1.5 V or less for 10 seconds when the throttle position sensor output is 1 V or more.
Manifold absolute pressure sensor
Related Data List 
DTC No.
Data List
P0106
MAP

HINT:
  1. If DTC P0106 is stored, the following symptoms may appear:
    1. Misfire
    2. Combustion noise
    3. Black smoke
    4. White smoke
    5. Lack of power


INSPECTION PROCEDURE

HINT:
  1. If DTCs P0105, P0107 and P0108 are output simultaneously, the manifold absolute pressure sensor circuit may have an open or short. Perform troubleshooting for these DTCs first.
  2. Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0106)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the tester on.

  1. Enter the following menus: Powertrain / Engine / DTC.

  1. Read the DTCs.

    Result 
    Display (DTC Output)
    Proceed to
    P0106 is output
    A
    P0106 and other DTCs are output
    B



B
GO TO DTC CHART (Click here)
A


2. REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR
  1. Replace the manifold absolute pressure sensor (Click here).


NEXT


3. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
  1. Connect the intelligent tester to the DLC3.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Start the engine.

  1. After warming up the engine, idle the engine for 10 seconds or more, then drive the vehicle under load (accelerator opening angle 10% or more) with the engine speed at 2500 rpm or less for 10 seconds.

  1. Confirm that the DTC is not output again.

    HINT:
    Perform the following procedure using the tester to determine whether or not the DTC judgment has been carried out.

    1. Enter the following menus: Powertrain / Engine / Utility / All Readiness.

    2. Input DTC P0106.

    3. Check that STATUS is NORMAL. If STATUS is INCOMPLETE or UNKNOWN, drive the vehicle for 5 minutes and then idle the engine for 5 minutes.


NEXT

END


← P0106 Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem (Sep 2011 – Dec 2011)P0110 Intake Air Temperature Circuit (+ P0112, P0113) (Sep 2011 – Dec 2011) →