2011-2013 Land Cruiser · Service Manual Power Source / Network

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE GENERATOR PULLEY
  1. Mount the generator in a vise between aluminum plates.

  1. A187035E04
    Install SST 1-A to the pulley shaft.
    SST
    09820-63011   (09820-06010, 09820-06021)

    HINT:
    SST 1-A and B
    09820-06010
    SST 2
    09820-06021

  1. Insert SST 1-B to SST 1-A.

  1. Hold SST 1-A with a torque wrench and turn SST 1-B clockwise with the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    NOTICE:
    Check that SST is secured on the rotor shaft.

  1. A187036E04
    Insert SST 2 and attach it to the pulley nut.
    Text in Illustration 
    V100135
    Insert

  1. A187037E02
    To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove SST 2 from the generator.

  1. A187038E04
    Turn SST 1-B in the direction shown in the illustration, and then remove SST 1-A and SST 1-B.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

  1. Remove the pulley nut and pulley.


2. REMOVE GENERATOR REAR END COVER

  1. A230483
    Remove the 3 nuts and generator rear end cover.


3. REMOVE TERMINAL INSULATOR

A230484

4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A230485
    Remove the 2 screws and brush holder.


5. REMOVE GENERATOR COIL ASSEMBLY

  1. A230486
    Remove the 4 bolts.

  1. A156415E03
    Using SST, remove the generator coil assembly.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
    Text in Illustration 
    *a
    Hold
    V100135
    Turn


6. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A156421
    Remove the generator washer.

  1. A230487
    Remove the generator rotor assembly.


7. INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A156418
    Check that the drive end frame bearing is not rough or worn.
    If necessary, replace the generator drive end frame bearing.


8. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A156416
    Remove the 4 screws and retainer plate.

  1. A156417E01
    Using SST and a hammer, tap out the bearing.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← REMOVAL (from Jan 2012)DISASSEMBLY (from Jan 2012) →