REASSEMBLY
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. INSTALL GENERATOR DRIVE END FRAME BEARING |
Using SST and a press, press in a new bearing.

- SST
- 09950-60010
(09951-00500)
09950-70010 (09951-07100)
Install the retainer plate with the 4 screws.
- Torque:
- 3.0 N*m{ 30 kgf*cm , 26 in.*lbf }
| 2. INSTALL GENERATOR ROTOR ASSEMBLY |
Install the generator rotor to the drive end frame.
Place the generator washer on the rotor.
| 3. INSTALL GENERATOR COIL ASSEMBLY |
Using a 22 mm socket wrench and press, slowly press in the coil assembly.

Install the 4 bolts.
- Torque:
- 7.5 N*m{ 76 kgf*cm , 66 in.*lbf }
| 4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
While pushing the 2 brushes into the generator brush holder, insert a pin with a diameter of 1.0 mm (0.0394 in.) into the brush holder hole.

Text in Illustration *1
Pin
Install the generator brush holder with the 2 screws.

- Torque:
- 1.8 N*m{ 18 kgf*cm , 16 in.*lbf }
Pull out the pin from the generator brush holder.
Text in Illustration *1
Pin
| 5. INSTALL TERMINAL INSULATOR |
Install the terminal insulator to the generator coil.
- NOTICE:
- Pay attention to the mounting orientation of the terminal insulator.
| 6. INSTALL GENERATOR REAR END COVER |
Install the generator rear end cover with the 3 nuts.
- Torque:
- 4.6 N*m{ 46 kgf*cm , 40 in.*lbf }
| 7. INSTALL GENERATOR PULLEY |
Temporarily install the generator pulley by hand.
Mount the generator in a vise between aluminum plates.
Install SST 1-A to the pulley shaft.

- SST
- 09820-63011
(09820-06010, 09820-06021)
- HINT:
SST 1-A and B
09820-06010
SST 2
09820-06021
Install SST 1-B to SST 1-A.
Hold SST 1-A with a torque wrench and turn SST 1-B clockwise with the specified torque.
- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
Text in Illustration *a
Hold


Turn
- NOTICE:
- Check that SST is secured to the rotor shaft.
Insert SST 2 and attach it to the pulley nut.

Text in Illustration 

Insert
Tighten the pulley nut by turning SST 1-A in the direction shown in the illustration.

- Torque:
- 133 N*m{ 1351 kgf*cm , 98 ft.*lbf }
Text in Illustration *a
Hold
*b
Turn
- HINT:
- Hold the adjustable wrench against the vise and tighten the nut securely.
Remove the generator from SST 2.
Turn SST 1-B, and then remove SST 1-A and B.

Text in Illustration *a
Hold


Turn
Turn the pulley and check that the pulley moves smoothly.
