2011-2013 Land Cruiser · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A178461
    Remove the 10 bolts and No. 1 engine under cover.


4. REMOVE NO. 2 ENGINE UNDER COVER

  1. A178462
    Remove the 2 bolts and No. 2 engine under cover.


5. REMOVE PROPELLER SHAFT HEAT INSULATOR

  1. C172294E01
    Remove the 2 bolts and insulator.


6. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

  1. for 1GR-FE, 2UZ-FE and Center Grease Fitting type:

    1. C172295E01
      Place matchmarks on the propeller shaft flange and transfer flange.

    2. Remove the 4 nuts and 4 washers.

    3. C172296E01
      Place matchmarks on the propeller shaft flange and differential.

    4. Remove the 4 nuts and 4 washers.

    5. Remove the front propeller shaft.

  1. for 1VD-FTV:

    1. C177452E01
      Place matchmarks on the propeller shaft flange and transfer flange.

    2. Remove the 4 nuts and 4 washers.

    3. C177453E01
      Place matchmarks on the propeller shaft flange and differential.

    4. Remove the 4 nuts and 4 washers.

    5. Remove the front propeller shaft.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →