2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P2226 Barometric Pressure Circuit

Diagnostic trouble codes · Vehicles built from Jan 2012

Also covers:

DESCRIPTION

To detect atmospheric pressure, the built-in atmospheric pressure sensor in the ECM is used. Using the atmospheric pressure, the ECM corrects the injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.
P2226 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Engine switch on (IG) for 1 second
Atmospheric pressure sensor voltage is 1.4 V or less, or 4.0 V or higher for 0.5 seconds.
(1 trip detection logic)
ECM
P2228 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Engine switch on (IG) for 1 second
Atmospheric pressure sensor voltage is 1.4 V or less for 0.5 seconds.
(1 trip detection logic)
ECM
P2229 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Engine switch on (IG) for 1 second
Atmospheric pressure sensor voltage is 4.0 V or higher for 0.5 seconds.
(1 trip detection logic)
ECM
Related Data List 
DTC No.
Data List
P2226
P2228
P2229
  1. Atmosphere Pressure
  2. MAP

HINT:
  1. When the engine switch is on (IG), the intake manifold pressure, "MAP", is approximately equal to atmospheric pressure.
  2. Under standard atmospheric pressure conditions, the output of the atmospheric pressure sensor is 101 kPa. For every 100 m increase in elevation, pressure drops by 1 kPa. This varies by weather (high atmospheric pressure, low atmospheric pressure).
  3. If DTC P2226, P2228 and/or P2229 is stored, the following symptoms may appear:
    1. Misfire
    2. Combustion noise
    3. Black smoke
    4. White smoke


INSPECTION PROCEDURE

NOTICE:
  1. After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
  2. After replacing the fuel supply pump assembly, the ECM needs initialization (Click here).
  3. After replacing an injector assembly, the ECM needs registration (Click here).

HINT:
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


2. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Clear the DTCs (Click here).

  1. Turn the engine switch off and wait for 30 seconds or more.

  1. Turn the engine switch on (IG) and wait for 1 second or more.

  1. Confirm that the DTC is not output again.


NEXT

END


← P2195 Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1) (+ P2197) (from Jan 2012)P2237 Oxygen (A/F) Sensor Pumping Current Circuit / Open (Bank 1 Sensor 1) (+ 9 more codes) (from Jan 2012) →