2011-2013 Land Cruiser · Service Manual Brake

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


SYSTEM DESCRIPTION

HINT:
The skid control ECU is a single unit with the hydraulic brake booster.

  1. Multi-terrain ABS

    1. The ABS helps prevent the wheels from locking when the brakes are applied firmly or when braking on a slippery surface.
    2. The Multi-terrain ABS detects off-road driving on dirt, sand, etc., and improves the brake feeling during off-road driving by using a function to automatically change to optimal ABS control.
    C176421E01
    Operation description (ABS)
    The skid control ECU detects wheel lock condition by receiving vehicle speed signals from each speed sensor, and sends control signals to the pump motor and solenoid valve. The pump motor and solenoid valve avoid wheel lock by controlling the oil pressure of each wheel cylinder.
    The ABS warning light comes on when the ABS system is malfunctioning.
    C162676E01
    Operation description (Multi-terrain ABS)
    The skid control ECU detects road surface, such as dry asphalt, wet asphalt, snow, ice, sand, mud, gravel, and dirt by using engine torque information from the ECM, vehicle body acceleration information from the G sensor, and vehicle wheel speed information from each wheel speed sensor.
    The skid control ECU changes the slip ratio in accordance with the detected road surface.

  2. EBD (Electronic Brake force Distribution)
    The EBD control utilizes the ABS, realizing proper brake force distribution between the front and rear wheels in accordance with driving conditions.
    In addition, when braking while cornering, it also controls the brake forces of the right and left wheels, helping to maintain vehicle behavior.
    C176422E01
    Operation description
    The skid control ECU receives the speed signal from each speed sensor to detect the slip condition of the wheels and sends the control signal to the solenoid.
    The solenoid valve controls oil pressure of the rear wheel cylinder and splits the control power properly between the rear wheels and the right and left wheels.
    Both the ABS and BRAKE warning lights come on to indicate a malfunction in the EBD system.

  3. BA (Brake Assist)
    The primary purpose of the brake assist system is to provide an auxiliary brake force to assist the driver who cannot generate a large enough brake force during emergency braking, thus helping to maximize the vehicle braking performance.
    C176423E01
    Operation description
    The skid control ECU receives a speed signal from each speed sensor and the oil pressure signal from the master cylinder pressure sensor to determine whether brake assist is necessary or not. If brake assist is deemed necessary, the ECU sends control signals to the pump motor and solenoid. The pump and the solenoid valve then control the pressure applied to each wheel cylinder.
    The ABS warning light comes on to indicate a malfunction in the BA system.

← SYSTEM DIAGRAM (from Jan 2012)SYSTEM DESCRIPTION (from Jan 2012) →