2011-2013 Land Cruiser · Service Manual Brake

CHECK FOR INTERMITTENT PROBLEMS

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK FOR INTERMITTENT PROBLEMS

HINT:
A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be monitored using the ECU data monitor function of the intelligent tester.

  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the intelligent tester on.

  5. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

  6. Select areas where momentary interruption should be monitored.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR Speed Open
    Front speed sensor RH open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    FL Speed Open
    Front speed sensor LH open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    RR Speed Open
    Rear speed sensor RH open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    RL Speed Open
    Rear speed sensor LH open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    EFI Communication Open
    ECM communication open detection / Error or Normal
    ERROR: Momentary interruption
    NORMAL: Normal
    -
    Yaw Rate Open
    Yaw rate sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    Deceleration Open
    Deceleration sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    Steering Open
    Steering angle sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -

    HINT:
    1. A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
    2. If the ERROR display remains on, check the continuity between the ECU and the sensors, or between ECUs.

    3. C154775E02
      The ERROR display remains on for 1 second after the harness signal changes from momentary interruption (open circuit) to normal condition.

  7. C173108
    While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs. If the display changes, the connector and/or wire harness is in momentary interruption (open circuit). Repair or replace the connector and/or wire harness, as one of them is faulty.

← HOW TO PROCEED WITH TROUBLESHOOTING (from Sep 2011)CHECK FOR INTERMITTENT PROBLEMS (from Jan 2012) →