2011-2013 Land Cruiser · Service Manual Brake

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR WHEEL LH

2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH

  1. C172183
    Remove the 2 bolts and disconnect the rear disc brake cylinder.

    NOTICE:
    1. Do not disconnect the flexible hose from the disc brake cylinder.
    2. Do not twist or bend the flexible hose.

  1. Hang the disc brake cylinder with a piece of wire.


3. REMOVE REAR DISC

  1. C172168E01
    Put matchmarks on the rear disc and axle hub if planning to reuse the disc.

  1. C155453
    Turn the shoe adjuster until the disc turns freely, and then remove the disc.


4. REMOVE PARKING BRAKE SHOE RETURN SPRING

  1. C172171E01
    Using SST, remove the return spring.
    SST
    09703-30011  


5. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH

  1. C172174E01
    Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.
    SST
    09718-00011  

  1. C172180
    Disconnect the tension spring from the No. 1 parking brake shoe.

  1. C172179
    Remove the No. 1 parking brake shoe and shoe adjuster screw set.


6. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH

  1. C172175E01
    Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.
    SST
    09718-00011  

  1. Remove the No. 2 parking brake shoe.


7. REMOVE PARKING BRAKE SHOE LEVER LH
  1. Disconnect the No. 3 parking brake cable from the parking brake shoe lever.

  1. C172177
    Remove the parking brake shoe lever.


8. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY

  1. C170909
    Remove the bolt and No. 3 parking brake cable.


9. REMOVE PARKING BRAKE ANCHOR BLOCK

  1. C172176
    Remove the 2 nuts and anchor block.

← COMPONENTS (from Sep 2011)INSPECTION (from Sep 2011) →