2011-2013 Land Cruiser · Service Manual Brake

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. INSTALL PARKING BRAKE ANCHOR BLOCK

  1. C172176
    Install the anchor block with the 2 nuts.

    Torque:
    86 N*m{ 877 kgf*cm , 63 ft.*lbf }


2. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

  1. C170909
    Connect the No. 3 parking brake cable with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


3. INSTALL PARKING BRAKE SHOE LEVER LH

  1. C177128E01
    Apply high temperature grease to the parking brake anchor block.

  1. Install the parking brake shoe lever to the No. 3 parking brake cable.

    NOTICE:
    Be carefully to distinguish between the parking brake shoe lever RH and LH.


4. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
  1. Apply high temperature grease to the areas of the backing plate that contact the shoe.

  1. C172175E01
    Using SST, install the No. 2 parking brake shoe with the shoe hold down spring pin, compression spring and shoe hold down spring cup.
    SST
    09718-00011  


5. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
  1. Apply high temperature grease to the areas of the backing plate that contact the shoe.

  1. C172178E01
    Apply high temperature grease to the thread and all joining areas of the parking brake shoe adjuster screw set.

  1. C172179
    Set the No. 1 parking brake shoe and shoe adjuster screw set in place.

  1. C172180
    Connect the tension spring.

  1. C172174E01
    Using SST, install the shoe hold down spring pin, compression spring and shoe hold down spring cup.
    SST
    09718-00011  


6. INSTALL PARKING BRAKE SHOE RETURN SPRING

  1. C172171E01
    Using SST, install the shoe return spring.
    SST
    09703-30011  


7. CHECK PARKING BRAKE INSTALLATION

  1. Check that each part is installed properly.

    C172182E01


8. INSTALL REAR DISC

  1. C172168E01
    While aligning the matchmarks, install the rear disc.


9. CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH

  1. C172183
    Connect the rear disc brake cylinder with 2 new bolts.

    Torque:
    95 N*m{ 969 kgf*cm , 70 ft.*lbf }

    NOTICE:
    1. Do not twist the brake hose.
    2. Make sure that the bolts are free from damage and foreign matter.
    3. Do not overtighten the bolts.


10. ADJUST PARKING BRAKE
(Click here)

11. INSTALL REAR WHEEL LH

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }

← INSPECTION (from Sep 2011)PRECAUTION (Sep 2011 – Dec 2011) →