2011-2013 Land Cruiser · Service Manual Brake

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


3. REMOVE REAR FLEXIBLE HOSE LH

  1. C170918
    Remove the union bolt and gasket, and then remove the flexible hose from the disc brake cylinder.

  1. C170917E01
    Disconnect the brake tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.

    NOTICE:
    1. Do not bend or damage the brake tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

  1. Remove the clip.


4. REMOVE REAR FLEXIBLE HOSE

  1. C177141E01
    Disconnect each brake tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.

  1. Remove the 2 clips.

  1. Remove the flexible hose.

  1. C177143E01
    Disconnect each brake tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.

  1. Remove the 2 clips.

  1. Remove the flexible hose.


5. REMOVE NO. 6 FLEXIBLE HOSE BRACKET

  1. C177145
    Remove the bolt and bracket from the rear axle housing.

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →