DISASSEMBLY
Removal / installation · Vehicles built from Sep 2011
| 1. REMOVE REAR SIDE NO. 2 AIR DUCT |
![]() ![]() |
Remove the 3 screws and duct.
| 2. REMOVE REAR SIDE NO. 3 AIR DUCT |
![]() ![]() |
Remove the 2 screws and duct.
| 3. REMOVE DRAIN COOLER HOSE |
![]() ![]() |
Remove the screw.
Detach the claw and remove the drain hose.
| 4. REMOVE REAR AIR MIX DAMPER SERVO SUB-ASSEMBLY |
![]() ![]() |
Disconnect the connector.
Remove the 2 screws and damper servo.
| 5. REMOVE REAR MODE DAMPER SERVO SUB-ASSEMBLY |
![]() ![]() |
Remove the 2 screws and plate cover.
Disconnect the connector.

Remove the 2 screws and damper servo.
| 6. REMOVE NO. 2 AIR MIX DAMPER SERVO SUB-ASSEMBLY |
![]() ![]() |
Disconnect the connector.
Remove the 2 screws and damper servo.
| 7. REMOVE AIR CONDITIONER ACCESSORY ASSEMBLY |
![]() ![]() |
Remove the packing.
Remove the bolt and 4 screws.

Using pliers, grip the claws of the clips and slide the 2 clips.
Remove the air conditioner accessory assembly.
Remove the 2 O-rings from the air conditioner accessory assembly.
| 8. REMOVE REAR COOLING UNIT EXPANSION VALVE |
![]() ![]() |
Disconnect the connector.
Detach the clamp.
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and expansion valve.
| 9. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() ![]() |
Remove the screw and detach the claw.
Remove the heater clamp.
Remove the heater radiator.

| 10. REMOVE REAR BLOWER MOTOR |
![]() ![]() |
Disconnect the connector.
Remove the 3 screws and blower motor.
| 11. REMOVE BLOWER MOTOR CONTROLLER |
![]() ![]() |
Disconnect the connector.
Remove the 2 screws and blower motor controler.
| 12. REMOVE EVAPORATOR SUB-ASSEMBLY |
![]() ![]() |
Remove the 12 screws and rear cooling unit case LH.
Remove the evaporator.
Remove the 2 O-rings from the evaporator.

| 13. REMOVE REAR EVAPORATOR TEMPERATURE SENSOR |
![]() ![]() |
Detach the 2 claws and remove the sensor.
| 14. REMOVE WIRING AIR CONDITIONING HARNESS SUB-ASSEMBLY |













