2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT AUTOMATIC LIGHT CONTROL SENSOR (SOLAR SENSOR)

B109993E48
  1. Connect the battery positive (+) lead to terminal 6 and the negative (-) lead to terminal 3, then measure the according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (TSL) - 3 (CLTE)
    Sensor subject to electric light
    0.5 V to 3.0 V
    1 (TSL) - 3 (CLTE)
    Sensor covered with a cloth
    0.5 V or less
    2 (TSR) - 3 (CLTE)
    Sensor subject to electric light
    0.5 V to 3.0 V
    2 (TSR) - 3 (CLTE)
    Sensor covered with a cloth
    0.8 V or less

    If the result is not as specified, replace the automatic light control sensor (solar sensor).

    HINT:
    1. As the inspection light is moved away from the sensor, the voltage increases.
    2. Use an incandescent lamp for inspection. Bring it within 30 cm (11.8 in.) of the A/C solar sensor.

← REMOVAL (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →