REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE FRONT DOOR SCUFF PLATE LH |
![]() ![]() |
Detach the 7 claws and 4 clips, and remove the scuff plate.
| 3. REMOVE COWL SIDE TRIM BOARD LH |
![]() ![]() |
Remove the cap nut.
Detach the 2 clips and remove the cowl side trim board.
| 4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() ![]() |
Remove the 2 screws.
Detach the 3 claws.
Disconnect the connectors and remove the No. 1 instrument panel under cover.
| 5. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL |
![]() ![]() |
Using a screwdriver, detach the 2 claws and open the hole cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration *1
Protective Tape
w/ Driver Side Knee Airbag:
Remove the 2 bolts.
Detach the 16 claws.


w/o Driver Side Knee Airbag:
Remove the 2 bolts.
Detach the 9 claws.


for Automatic Air Conditioning System:

Detach the 2 claws and remove the room temperature sensor.
Detach the 2 claws and disconnect the 2 control cables.

Disconnect the connectors and remove the lower No. 1 instrument panel finish panel.
| 6. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY |
Remove the 5 bolts and driver side knee airbag.

Disconnect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 7. REMOVE PUSH ROD PIN |
Remove the clip and push rod pin from the brake pedal lever.

| 8. REMOVE STOP LIGHT SWITCH ASSEMBLY |
Disconnect the stop light switch connector.
Remove the stop light switch (Click here).
| 9. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY |
Loosen the hexagon bolt.

- HINT:
- Hold the bolt in place and loosen the nut.
- NOTICE:
- Only loosen the nut. Do not remove the bolt or nut.
Remove the brake pedal support reinforcement set bolt.
Remove the 4 nuts and brake pedal support assembly.





