2011-2013 Land Cruiser · Service Manual Steering

TERMINALS OF ECU

System information · Vehicles built from Sep 2011


CHECK STEERING LOCK ECU
B106649E26
  1. Disconnect the E26 steering lock ECU connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E26-1 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    E26-2 (SGND) - Body ground
    BR - Body ground
    Signal ground
    Always
    Below 1 Ω
    E26-6 (IG2) - E26-1 (GND)
    L - W-B
    IG signal input
    Engine switch on (IG)
    11 to 14 V
    E26-7 (B) - E26-1 (GND)
    P - W-B
    Power source
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the E26 steering lock ECU connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E26-3 (IGE) - E26-1 (GND)
    SB - W-B
    Power source for motor drive
    Motor operating
    Below 1 V
    E26-3 (IGE) - E26-1 (GND)
    SB - W-B
    Power source for motor drive
    Motor not operating
    11 to 14 V
    E26-4 (SLP1) - E26-2 (SGND)
    LG - BR
    Unlock position sensor output signal
    Steering locked
    11 to 14 V
    E26-4 (SLP1) - E26-2 (SGND)
    LG - BR
    Unlock position sensor output signal
    Steering lock unlocked
    Below 1 V
    E26-5 (LIN) - E26-2 (SGND)
    O - BR
    LIN communication bus
    Engine switch on (IG)
    Pulse generation
    If the result is not as specified, there may be a malfunction on the wire harness side.

← PROBLEM SYMPTOMS TABLE (from Jan 2012)DIAGNOSIS SYSTEM (from Sep 2011) →