Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
DESCRIPTION
This circuit supplies power source voltage from the battery to terminal B of the steering lock ECU. The diagnosis information of the steering lock ECU is transmitted to the intelligent tester via the certification ECU (smart key ECU assembly) as the steering lock ECU is not connected to the CAN communication system.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following steps to wake up the ECU:
With the engine switch off, open the driver door. Then (with the engine switch still off) open and close any door several times at 1.5 second intervals.
1. INSPECT FUSE (STR LOCK)
Remove the STR LOCK fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
STR LOCK fuse
Always
Below 1 Ω
NG
REPLACE FUSE
OK
2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BATTERY)
Disconnect the E26 steering lock ECU connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
E26-7 (B) - Body ground
Always
11 to 14 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
3. CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BODY GROUND)
Disconnect the E26 steering lock ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
E26-1 (GND) - Body ground
Always
Below 1 Ω
E26-2 (SGND) - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
GO TO STEERING LOCK SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)