2011-2013 Land Cruiser · Service Manual Power Source / Network

Combination Meter ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
Either condition is met:
  1. "Combination Meter" is not displayed on the "Bus Check" screen.
  2. "Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside of combination meter assembly
  2. Combination meter assembly

WIRING DIAGRAM

C175530E14

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)

  1. E207341E03
    Disconnect the E7 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E7-15 (ET) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E7-17 (B) - Body ground
    Always
    11 to 14 V
    E7-18 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Combination Meter Assembly)
Result 
Result
Proceed to
OK (w/ Multi-information Display)
A
OK (w/o Multi-information Display)
B
NG
C


B
REPLACE COMBINATION METER ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Combination Meter ECU Communication Stop Mode (Sep 2011 – Dec 2011)Center Airbag Sensor Communication Stop Mode (Sep 2011 – Dec 2011) →